Yamato DF412/612 - Page 23

20
4. OPERATION PROCEDURE
Auto Stop Operation
2
Select auto stop mode
Press key repeatedly until both FIXED TEMP
and AUTO STOP lamps light.
 Fixed Temperature mode is factory default.
Once mode has been changed, the last mode
run will be selected on subsequent startups.
3
Set temperature and stop timer/clock
1) Press .
2) Select stop TIME or CLOCK (lamp in upper-left
of lower display) using and press
.
3) Set TIME (setting range: 0
～
99hr
：
59min
）
or
CLOCK (24-hour time system) in upper display
and press .
4) Set temperature in lower display and press
.
Example 1. Auto Stop mode set to timer:
Operation stops automatically 35 hours and 30 minutes
after 250℃ temperature setting is reached.
Example 2. Auto Stop mode set to clock:
Operation stops automatically at 15:00 (3:00PM).