Yamato DF412/612 - Wait Function Explanation

35
4. OPERATION PROCEDURE
Programming Procedure
8-3
Enter “ ” (0 hours, 30 minutes)
 Entering “ ” on final step makes time setting
indefinite (must be stopped manually).
x3
8-4
Enter “ ” (No repeat destination）
8-5
Enter “ ” (No repeats)
8-6
Set wait function to .
Wait lamp flashes.
8-7
Set fan speed to (Low)
- FAN lamp flashes.
8-8
↓
Set “ ” setting to .
- All program setting lamps flash.
 Always set to in the final step of
programs. Programs without set to
will not be recognized as a complete program
and will not run.
 Duplicating and using program planning sheet on P.71. of this manual is recommended.
x3