17
Operation Method
Auto Start Operation
3. Stop/terminate timer operation
• The operation starts automatically at setting time.
• Press the START/STOP key for one second to stop or terminate
operation. The screen returns to the initial setting screen.
To correct or check setting…
Changing the setting temperature or time during operation is possible by pressing the TIMER key. Use
the "▼▲" to change the setting value. Press the ENTER key respectively after changing the setting.
(Note that the time setting is required using the value calculated by adding a new additional time to the
already passed time in this case.)
Press the "▼" to display the setting temperature, operation mode and residual time on the setting
temperature screen.
Note that the setting condition is impossible to change once starting the operation after passing the auto
start operation time. In this case, stop the operation by pressing START/STOP key, and reset to initial
status.
To Next Page
Loading...
