Yanmar 2V Series - Checking Engine Oil; Adding Engine Oil; ADJUST ENGINE SPEED

BEFORE YOU OPERATE
2V Operation Manual
37
Checking Engine Oil
1. Make sure engine is level.
2. Remove oil cap / dipstick (Figure 4, (1)) and
wipe with clean cloth.
Figure 4
3. Fully reinsert oil cap / dipstick but do not
screw in.
4. Remove oil cap / dipstick. The oil level should
be between upper (Figure 4, (2)) and lower
(Figure 4, (3)) lines on the oil cap / dipstick.
5. Fully reinsert oil cap / dipstick (Figure 4, (1))
and hand-tighten. Over-tightening the oil
cap / dipstick will damage it.
Adding Engine Oil
1. Make sure engine is level.
2. Remove oil cap / dipstick (Figure 5, (1)).
Figure 5
3. Add indicated amount of engine oil at the side
engine oil filler port (Figure 5, (2)).
4. Wait three minutes and check oil level.
5. Add more oil if necessary.
6. Replace oil cap / dipstick (Figure 5, (1)) and
hand-tighten. Over-tightening may damage the
cap.
0002421
(1)
(2)
(3)
(2)
0002421B
(1)