Yanmar 3JH40 - Page 5

TABLE OF CONTENTS
JH Series Operation Manual iii
REMOTE CONTROL HANDLE OPERATION ......... 65
Acceleration and Deceleration........................... 65
Shifting the Engine ............................................ 65
Switching to Trolling (KMH4A Only) .................. 66
CAUTIONS DURING OPERATION ......................... 67
SHUTTING DOWN THE ENGINE ........................... 69
Normal Shutdown .............................................. 69
Engine Auxiliary Stop Switch ............................. 70
Auxiliary Stop Switch
(Option: It is recommended that this switch is
installed in an easily accessible location.) ......... 71
CHECKING THE ENGINE AFTER OPERATION .... 71
OPERATION
(VC10: VESSEL CONTROL SYSTEM) ................... 72
Starting the Engine ............................................ 72
Station Protect ................................................... 74
Sys on by ID, Start by ID ................................... 74
Owner ID Change .............................................. 74
If the Engine Fails to Start ................................. 75
Starting at Low Temperatures ........................... 75
After the Engine has Started ............................. 75
WARM UP MODE (SHIFT DISCONNECT) ............. 76
THROTTLE AND SHIFT CONTROL........................ 77
Neutral ............................................................... 77
Forward ............................................................. 77
Reverse ............................................................. 77
Forward (Reverse) to Reverse (Forward).......... 77
ENGINE SPEED LIMIT MODE ................................ 78
CAUTIONS DURING OPERATION ......................... 78
SHUT-DOWN THE ENGINE (STOPPING).............. 80
Normal Stopping................................................ 80
Normal Stopping
(for folding / feathering propeller) ...................... 81
Emergency Stop ................................................ 83
CONTROL THE BACKUP PANEL........................... 84
CHECKING THE ENGINE AFTER OPERATION .... 85
OPERATION
(VC20: VESSEL CONTROL SYSTEM) ................... 86
Starting the Engine ............................................ 86
Station Protect ................................................... 88
Sys on by ID, Start by ID ................................... 88
Owner ID Change .............................................. 88
YANMAR E-key ................................................. 89
If the Engine Fails to Start ................................. 93
Starting at Low Temperatures ........................... 93
After the Engine has Started ............................. 93
3JH40_4JH45_4JH57_4JH80_4JH110_EN_OPM.book iii ページ ２０２２年９月２２日 木曜日 午後６時１７分