ENGINE OPERATION
58
TNV Operation Manual
SHUTTING DOWN THE ENGINE
Follow these steps to shut down the engine:
1. Disengage the PTO and / or set the
transmission to NEUTRAL.
2. Set the engine speed control to its lowest
setting.
3. Run the engine at low idle speed for at least
five minutes before you shut it down.
Figure 6
Figure 7
4. Turn the key to the OFF position
(Figure 6, (1)) or (Figure 7, (1)) and remove
it from the key switch.
5. If the engine will not be used for six months or
longer, follow the additional instructions in
Long Term Storage on page 103.
CAUTION
0000008en
For maximum engine life, Yanmar
recommends that when shutting the
engine down, you allow the engine to
idle, without load, for 5 minutes. This
will allow the engine components that
operate at high temperatures, such as
the turbocharger (if equipped) and
exhaust system, to cool slightly before
the engine itself is shut down.
AUX
0000009C
(1)
0000025D
(1)
To Next Page
Loading...
