16
Safety symbols
The purpose of safety symbols is to bring your attention
to possible dangers. The safety symbols and explanations
require your careful attention and full understanding. The
symbol warnings do not, by themselves, eliminate any
danger. The instructions and warnings are not substitute
to accidents prevention measures.
Overow valve with pressure switch
The overow valve prevents the permissible working
pressure from being exceeded. If the lever on the trigger
gun is released the pressure switch turns turns the pump
off and the high-pressure washer stops. If the lever is
pulled the pump is turned on again.
Flow monitors
DO NOT alter the original diameter of the spray head
nozzle - HAZARDOUS ALTERATION OF OPERATING
PERFORMANCE.
Attention!
Connecting to mains power supply.
Connecting the high pressure washer to a supply
system,the max allowed impedance is 0.371 OHM.
Consult with the supply authority that the equipment is
connected only to a supply of that impedance or less.
SYMBOLS
PRODUCT SAFETY WARNINGS
To Next Page
Loading...
Need help?
General
