22
OPERATION
WARNING: Wear suitable clothing, ear and eye protection when working with the
equipment. Ensure that the equipment is functional before each use. Ensure that the
mains voltage value matches the label on the equipment. Check the condition of the
machine:
– Check machine for visual defects.
– Check that all parts of the machine have been securely tted.
– Check that the water connector and the high-pressure hose are tight.
Starting and stopping
NOTE: Put the high pressure washer on an area of at ground. Stand in a secure
and stable position.
Starting:
1. Open the water inlet valve.
2. To switch the machine on, set the ON/OFF switch to ON. (Fig. K)
3. Unlock the safety trigger on the spray gun and press the trigger until there is a steady
stream of water. (Fig. L)
Stopping:
1. Release the trigger. Lock the safety trigger on the spray gun.
2. To switch the machine off, set the ON/OFF switch to OFF.
3. Close the water inlet valve.
CAUTION: Risk of machine damage!
Never operate the machine without water inlet as dry running may damage the
pump. Use a water lter if the inlet water is contaminated.
Working with the electric high pressure washer
Risk of fatal injury!
Use special care when cleaning tyres. Vehicle tyres/tyre valves may become damaged or
burst when handled improperly. The rst sign of damage is discolouration. Damaged vehicle
tyres/tyre valves pose a life-threatening risk. Keep the jet at a distance of at least 30 cm!
Risk of fatal injury!
The high-pressure jet may be dangerous when handled improperly. The jet must not be
directed towards living beings (people, animals), live equipment or the machine itself.
Application
High pressure working. (Fig. M)
WARNING: Be prepared for the recoil force of the emitted water jet! Ensure that you
are standing rmly and that you are holding the gun securely, otherwise you could
injure yourself or other people.
To Next Page
Loading...
Need help?
General
