Yard force GM B41 - Starting and Stopping the Engine; Quick Start Guide

19
1. Clean the area around the petrol ller cap before removing. Remove the warning tag,
check the fuel level.
2. Rell the tank if the fuel level is low.
3. Refuel carefully to avoid overlling or spilling fuel. There should be no fuel in the ller
neck.
4. Clean up any overow or splashes of petrol before starting the engine.
5. Tighten the ller cap after lling, ensuring it is on tight.
START/STOP the engine
WARNING: The blade begins to rotate as soon as the engine is started.
NOTE: Do not operate the machine in enclosed or poorly ventilated areas as
the exhaust gas contains toxic substance. Keep hands, feet, hair and clothing
away from all the moving parts of the machine. The exhaust and other parts of
the machine will become hot during use. Make sure that the blade is securely
fastened before starting the engine.
NOTE: To start the engine, make sure that the spark plug boot is located on
the plug and the machine is lled with sufcient oil and petrol. When starting a
cold engine, press down the primer fully 3-5 times. (Fig. K)
WARNING! Too many presses on primer may cause engine to ood. When
starting a warm engine, the primer does not need to be used. If the engine
stops due to a lack of petrol, rell and press down the primer 3-5 times.
1. Stand behind the mower. Pull the engine Start/stop lever toward upper handle with one
hand and place the other hand on the starter handle. (Fig. L)
2. Pull the starter handle out approx. 10-15cm until you feel some resistance and then start
the engine with a sharp pull.
3. Once the engine is running, put the starter rope into the rope guide.
4. Release the engine start/stop lever; it will return to its initial position, the engine will
automatically switch off.
Starting procedure quick guide
1. Press the primer bulb 3-5 times.
2. Start/Stop bar activation
3. Pull cord handle
OPERATION