22 23
max. 8 m
min. 2 m
• If you need a narrow corridor to connect two patches of
lawn within the boundary, the corridor should be at least
2 metres wide and max. 8 m long.
Note: If your Robomower loses ground contact while
hitting an obstacle, the blade disc will stop immediately
to avoid any potential damage.
Locating the charging station
• When the battery is running low, the Robomower
will automatically return to the charging station. It
will approach the closest boundary wire and follow it
anticlockwise (without cutting) back to the charging
station. When fully charged, the Robomower will
automatically resume the interrupted working cycle. The
launch direction from the charging station - clockwise - is
hard-wired into the design and is impossible to change.
Recognising the boundary wire
• Note that before stopping and changing the direction,
the Robomower will overrun the boundary wire by 10
to 20 cm. Please keep this in mind when planning the
boundary wire installation.
SAFETY PRECAUTIONS SAFETY PRECAUTIONS
To Next Page
Loading...
