EasyManuals Logo

Yard force Y2GMB41PC00 User Manual

Yard force Y2GMB41PC00
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
14 15
STOP!
Do not start the engine before putting 500ml of SAE 30 oil into the engine.
Failure to do so will result in irreparable damage to the engine and invalidate
your warranty.
START/STOP the engine
WARNING: The blade begins to rotate as soon as the engine is started.
NOTE: Do not operate the machine in enclosed or poorly ventilated areas as the
exhaust gas contains toxic substance. Keep hands, feet, hair and clothing away from
all the moving parts of the machine. The exhaust and other parts of the machine will
become hot during use. Make sure that the blade is securely fastened before starting
the engine.
NOTE: to start the engine, make sure that the spark plug boot is located on the plug
and the machine is lled with sufcient oil and petrol. When starting a cold engine,
press down the primer fully 3-5 times.(see Fig.11)
WARNING! Too much presses on primer may cause engine ooded when starting a
warm engine, the primer does not need to be used. If the engine stops due to a lack
of petrol, rell and press down the primer 3~5 times.
1. Stand behind the mower. Pull the engine Start/stop lever toward upper handle with one
hand. And place the other hand on the starter handle.
2. Pull the starter handle out approx. 10-15cm until you feel a resistance and then start the
engine with a sharp pull.(see Fig.12)
OPERATION
Fig 11
x3
NOTE: If the engine fails to start after three pulls, repeat the process .
Fig 12
1
2
OPERATION
3. Once the engine is running, put the starter rope into the rope guide.
4. Release the engine start/stop lever, it will return to its initial position, the engine will
automatically switches off.
Starting procedure quick guide
1. Press the primer bulb (A) 3-5 times.
2. Start/Stop Bar Activation
3. Pull cord handle
Mowing
WARNING! Always observe the strictest safety procedures when using the
lawnmower. Carefully read the safety instructions of this manual before using the
lawnmower.
WARNING! Never open the safety ap when the grass bag has been detached (to be
emptied). And the engine is still running. The rotating blade can cause serious injuries!
1. Select your required setting.
2. Start the engine and allow it run.
3. Keep a rm grip on the upper handle with engine stop/start lever, and push it to start
mowing.
Good practice advice
1. Walk, never run with the mower, be very careful when mowing uneven or rough ground.
2. Mow across slopes, never up and down.
3. Be careful when changing the direction of the mower on a slope.
4. Do not mow excessively steep slopes.
5. The best result will be achieved if the grass is dry. Wet grass will tend to clog the blade
and the grass collection system.
6. Grass grows at different rates at different time of the year. Never use the lowest cutting
height for the rst cut of the season or in drought conditions.
7. Only about one third of the grass height should be cut.
PRIMER BULB 3~5
TIMES
STOP/START-LEVER
CLOSED
PULL STARTING
HANDLE
step 1 step2 step 3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yard force Y2GMB41PC00 and is the answer not in the manual?

Yard force Y2GMB41PC00 Specifications

General IconGeneral
BrandYard force
ModelY2GMB41PC00
CategoryLawn Mower
LanguageEnglish

Related product manuals