11
Read and follow the assembly instructions. Do not discard any parts or materials
until the unit is assembled. References to the right or left side of the edger are
from the viewpoint of the operator’s position behind the edger.
Do not operate edger if it is damaged or not completely and correctly
assembled.
Before doing any assembly or maintenance to the unit, remove the wire
from the spark plug.
Always wear ANSI compliant safety glasses with side shields while
assembling the edger.
• When used for its intended purpose, this device corresponds to the state
of the art, as well as to the current safety requirements at the time of its
introduction.
• The unit is designed to cut lawn areas in private house and hobby gardens.
• The device is not suitable for commercial or industrial use.
• Any other type of use is inappropriate.
• Improper use or modications to the device or the use of components that
are not tested and approved by the manufacturer may result in unforeseen
damage!
• Any use that deviates from its intended use and is not included in these
instructions is considered unauthorised use and relieves the manufacturer
from his or her legal liability.
The following components will be found in the carton.
Quantities shown in ( ).
1. (1) Edger
2. (1) Edger Operator’s Manual
3. (1) Upper Handle
4. (1) Control Rod
5. (1) Container of SAE 30 Engine Oil
6. (1) Parts bag containing the following:
(2) Hair Pins
(2) Plastic Wing Nuts (M8)
(2) M8x35mm Pipe Bolts
(1) Wire Tie
(1) Spark plug socket wrench w/ rod
To Next Page
Loading...
Need help?
General
