16
If further assistance is required, contact your authorized service dealer.
CAUSE ACTION
Cutting attachment bound with grass Stop the engine and clean cutting attachment
Cutting attachment out of line Refill with new line
Cutting head dirty Clean inner reel and outer spool
Line twisted when refilled Disassemble and rewind the line
CAUSE ACTION
Incorrect spark plug gap Adjust gap to 0.025” (0.635 mm) or clean/replace plug
CAUSE ACTION
Empty fuel tank Fill fuel tank with properly mixed fuel
Incorrect starting procedure Follow starting instructions shown in operator’s manual
Old or improperly mixed fuel Drain gas tank and add fresh fuel mixture
Fouled spark plug Replace or clean the spark plug
Plugged spark arrestor Clean or replace spark arrestor
Plugged fuel filter Replace fuel filter
ENGINE WILL NOT START OR STARTS BUT WILL NOT RUN
UNIT STARTS, BUT ENGINE HAS LOW POWER
ENGINE HESITATES
ENGINE RUNS ERRATICALLY
CAUSE ACTION
Air filter is plugged Replace or clean the air filter
Old or improperly mixed fuel Drain gas tank and add fresh fuel mixture
Improper carburetor adjustment Adjust according to the Carburetor Adjustments section
Choke lever is in incorrect position Move choke lever to Position 3
CAUSE ACTION
Improper carburetor adjustment Take to an authorized service dealer for an adjustment
CUTTING ATTACHMENT WILL NOT ADVANCE LINE
TROUBLESHOOTING
NO POWER UNDER LOAD
CAUSE ACTION
Improper carburetor adjustment Take to an authorized service dealer for an adjustment
CAUSE ACTION
Improper carburetor mixture/adjustment Take to an authorized service dealer for an adjustment
Old or improperly mixed fuel Drain gas tank and add fresh fuel mixture
UNIT SMOKES EXCESSIVELY
CAUSE ACTION
Weed wrap Remove weed wrap
CUTTING ATTACHMENT AND SHAFT ARE HOT TO THE TOUCH
To Next Page
Loading...
Need help?
General
