FORWARD ENGAGEMENT LEVER
It controls forward movement. It engages and
disengages the engine from the transmission. Depress
the lever to make the machine move forward. Release
the lever to make it stop.
REVERSE ENGAGEMENT LEVER
It controls reverse movement. It engages and
disengages the engine from the transmission. Depress
the lever to make the machine move backwards.
Release the lever to make it stop.
BRUSH ENGAGEMENT LEVER
It controls the brush operation. Press the lever to
start brush rotation. Release it to stop brush rotation.
THROTTLE CONTROL
It controls the engine and brush speed of the machine.
Ensure the throttle is fully engaged when starting and
adjust appropriately to clean.
PNEUMATIC TIRES
They move the power sweeper to any desired
location.
BRUSH DIRECTION CONTROL LEVER
It controls the direction of the brush. Press the
direction control lever and swing the brush 20
degrees to the right or left side.
BRUSH
It sweeps and removes snow, leaves, dirt, light gravel
and other materials from packing lots, sidewalks and
other surfaces.
ADJUSTABLE HEIGHT SUPPORT WHEELS
They play a role of supporting and turning the
machine and also for adjusting the height of the brush.
HANDLE ADJUSTMENT KNOBS
It provides different handle heights to make driving
position comfortable with the controls positioned
ergonomically.
Loosen both handle adjustment knobs, and pivot
handle forward or backward to desired height, and
then tighten the adjustment knobs securely.
RECOIL STARTER HANDLE
The handle is used to start the engine.
FUEL SHUT-OFF VALVE
The fuel shut – off has two position.
CLOSED
(
)
- use this position to service, transport, or store the
unit.
OPEN
(
) - use this position to run the unit.
CHOKE CONTROL
The choke control is used to choke the carburetor and
assist in starting the engine. The choke control slides
between the
CHOKE CLOSED
and
CHOKE OPEN
positions.
OPERATION
ADD OIL TO ENGINE
1. Make sure the power sweeper is on a at, level surface.
3. Using a funnel, add oil up to the FULL mark on the dipstick.
(See engine manual for oil capacity, oil recommendation, and
location of ll cap.)
The engine is shipped without oil. Do not start the
engine before adding oil.
DO NOT OVERFILL. Check engine oil level daily and
add as needed.
2. Remove the oil ll cap/dipstick
to add oil.
To Next Page
Loading...