Yardworks 054-5756-6 User Manual

model no. 054-5756-6 | contact us: 1.866.523.5218
14
ADDING BAR AND CHAIN LUBRICANT
Use a bar and chain lubricant with this product. It is designed for chains and chain oilers, and is
formulated to perform over a wide temperature range with no dilution required.
• Remove oil cap.
• Carefully pour the bar and chain oil into the tank.
• Wipe off excess oil and replace cap.
• Check and fill the oil tank when quick view oil indicator is below the MIN. line.
• Repeat as needed
.

NOTE: Chainsaw comes from the factory with no bar and chain oil added. The
level should also be checked after every 20 minutes of use and refilled as
needed.

IMPORTANT: To preserve natural resources, please recycle or dispose of
oil properly. Consult your local waste authority for information regarding
available recycling and/disposal options.
!
!
Operation
!
NOTE: It is normal for oil to seep from the saw when not in use. To prevent
seepage, empty the oil tank after each use then run for one minute. When
storing the unit for a long period of time (three months or longer) be sure the
chain is lightly lubricated. This will prevent rust on the chain and bar sprocket.
!
NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may
occur to the bar or chain.
C
H
A
IN
LU
B
R
IC
A
N
T
Oil Reservoir
Cap
Quick View Oil Indicator

Yardworks 054-5756-6 Specifications

General

Brand	Yardworks
Model	054-5756-6
Category	Chainsaw
Language	English