Yardworks 054-5756-6 User Manual

model no. 054-5756-6 | contact us: 1.866.523.5218 model no. 054-5756-6 | contact us: 1.866.523.5218
23
BUCKING LOGS UNDER STRESS
When the log is supported on one end, cut 1/3 the diameter from the underside. Then make
the finished cut by overbucking to meet the first cut. When the log is supported on both ends,
cut 1/3 of the diameter from the top overback. Then make the finished cut by underbucking the
lower 2/3 to meet the first cut.
Log supported at one end
Finishing cut
Load
1st cut 1/3 diameter
Log supported at both ends
Load 1st cut 1/3 diameter
Finishing cut
OVERBUCKING
Begin on the top side of the log with the bottom of the saw against the log; exert light pressure
downward. Note that the saw will tend to pull away from you.
UNDERBUCKING
Begin on the under side of the log with the top of the saw against the log; exert light pressure
upward. During underbucking, the saw will tend to push back at you. Be prepared for this
reaction and hold the saw firmly to maintain control.
Operation
OVERBUCKING
UNDERBUCKING

Yardworks 054-5756-6 Specifications

General

Brand	Yardworks
Model	054-5756-6
Category	Chainsaw
Language	English