22
Maintenance
• Wipe the dipstick clean and insert it back into the oil tank to check for the oil level.
• Remove the dipstick and check for oil level. The level of the refilled oil should be between
the 2 grooves of the dipstick. If not, add or decrease the amount of oil in the tank until the
level is between the 2 grooves of the dipstick.
• After verifying that the oil level is
correct, insert the bolt with dipstick
back into the oil tank. Tighten the
drain bolt in order to avoid leakage,
and then place the log splitter back
to its normal horizontal position.
Note:
• Check the oil level regularly and before starting the log splitter. Ensure that the oil level is
between the 2 grooves on the dipstick. When the oil level is below the lower groove, refill
the oil tank before operating the log splitter.
• Dispose of used oil only at an authorized collection point, or follow the regulations that
are in effect in your area.
Oil level
Oil drain bolt
with dipstick
w09a_YW_060_3772_0_9TElectricLogSplitter_GB.indd 22 2017/3/6 22:26:46
To Next Page
Loading...
Need help?
General
