YASKAWA AQ6370B - Page 293

9-18
IM 735302-01E
Setting the Screen Image Data Output Destination
You can specify the output destination used when the COPY key is pressed.
1.
Press SYSTEM.
2.
Press the MORE 1/4 soft key. The MORE 2/4 screen is displayed.
3.
Press the HARD COPY DEVICE soft key. The output destination selection menu
is displayed.
4.
Press the INTERNAL soft key to specify the built-in printer as the output
destination, or the FILE soft key to specify a file.
Note
• The INTERNAL key is not available if no built-in printer is installed.
• If you select FILE, files are saved to the current directory, which is set using the FILE key.
Turning Automatic Offset ON/OFF
You can specify whether to have the instrument perform automatic offset adjustment on
its internal amplifier circuit.
1.
Press SYSTEM.
2.
Press the MORE 1/4 soft key. The MORE 2/4 screen is displayed.
3.
Press the AUTO OFFSET OFF ON soft key. The settings turns ON and OFF each
time you press the key.
Note
• If the AUTO OFFSET key is OFF, the offset can fluctuate over time, and the level axis
performance can degrade. Always have it turned ON.
• When the AUTO OFFSET key is set to ON, is displayed at the bottom of the screen.
Explanation
Automatic Offset
When the AUTO OFFSET key is set to ON, the offset of the internal amplifier circuit is
adjusted at time intervals of approximately 10 minutes. (Default: ON)
If the AUTO OFFSET key is OFF, the auto-offset adjustment operation is not performed.
When you switch from OFF to ON, the offset adjustment is executed immediately.
When switched to ON, the offset adjustment is performed during repeat sweeping when
sweeping reaches 100%.
During a single sweep, the offset adjustment is performed when the sweep is completed.
During offset adjustment, “ZEROING” is displayed in the lower left corner of the screen.
ZEROING. . .
9.5 Other Settings