YASKAWA AQ6370B - Synchronous Sweep Measurement with the Tunable Laser Source

5-43
IM 735302-01E
Mesurement
1
2
3
4
5
6
7
8
9
10
11
App
Index
5.17 Synchronous Sweep Measurement with the
Tunable Laser Source
Procedure
Connecting to the Tunable Laser Source
Before turning on the power supply, make the following connections.
TRIGGER
IN
TRIGGER
OUT
ANALOG
OUT
SERIAL
(
RS - 232
)
ETHERNET
10/100BA SE - TX
VIDEO
OUT
(
SVGA
)
KBD
GP - IB1
(
IEEE488.1 /488.2
)
GP - IB2
(
IEEE488.1
)
(
FOR TLS,ETC.
)
WARNING
Do no t ope ra te wi th out r ead in g the
saf et y pre ca uti on s in th e u se r’ s man ua l.
MAI N PO WER
ON
OFF
100 - 240V A C
150VA
MAX
50/6 0Hz
FUSE
250V
T
5A
GP - IB
TRIGGER IN TRIGGER OUT
AQ6370B
Tunable Laser Source
Coaxial cable
GP-IB cable
Coaxial cable
Connecting the Turnable Laser Source When Using the AQ4321 Series
1.
Connect the GP-IB2 connector of the instrument and the GP-IB connector of the
AQ4321A/D using the GP-IB cable.
2.
Connect the TRIG IN terminal of the instrument and the SMPL TRIG OUT terminal
of the AQ4321A/D using a coaxial cable.
3.
Connect the TRIG OUT terminal of the instrument and the OSA SYNC IN terminal
of the AQ4321A/D using a coaxial cable.
Connecting the Turnable Laser Source When Using the AQ2200-136
1.
Connect the GP-IB2 connector of the instrument and the GP-IB connector of the
AQ2201/2202 mainframe using the GP-IB cable.
2.
Connect the TRIG IN terminal of the instrument and the SMPL TRIG OUT terminal
of the AQ2201/2202 mainframe using a coaxial cable.
3.
Connect the TRIG OUT terminal of the instrument and the TRIGGER IN terminal
of the AQ2201/2202 mainframe using a coaxial cable.