10.1 Upgrading the Firmware
8.
Press the YES (REBOOT) soft key.
Step 1 of the version upgrade begins. When step 1 of the upgrade is finished, the
instrument restarts automatically.
When the instrument restarts, step 2 of the upgrade begins at the same time.
When step 2 of the upgrade is finished, the power turns OFF automatically.
This concludes the version upgrade.
If you press the NO soft key, the upgrade is cancelled and the instrument returns
to the previous screen.
Note
The instrument can not up upgraded when connected to a network.
If connected to a network, the message, “Please disconnect LAN CABLE from LAN cable and
remove USB storage device” appears and the YES soft key is disabled. If you remove the
cable from the Ethernet connector, the message, “Please remove USB storage device” appears
and the YES soft key is enabled.
Displaying the Patch List
4.
Continuing on from step 3, press the PATCH LIST soft key.
A list of patches installed up to the present is displayed.
Explanation
When the version is upgraded, settings entered prior to the upgrade are initialized. If
necessary, save your settings.
To Next Page
Loading...