Setting of the Parameter “DUAL TRACE”
This function enables more precise analyses by measuring waveforms with different
measurement resolutions at trace A and trace B and also by performing measurements
with resolutions different in noise level from the signal level of each channel.
When “DUAL TRACE” is ON, targets for the analysis of each trace will be:
TRACE A: trace subject to channel detection
TRACEA:calculationtracesλiandLi
TRACE B: noise level LNi calculation trace
OUTPUT SLOPE Function
The parameter “OUTPUT SLOPE” provides a function to obtain the least square
approximation curve of channel peaks. This function makes it possible to measure gain
tilts. If “OUTPUT SLOPE” is set to ON, results will be displayed in the waveform display
section and in the analysis table.
Appendix 4 Details of WDM Analysis Function
To Next Page
Loading...