YASKAWA AQ6370B - Page 343

App-31
IM 735302-01E
Appendix
1
2
3
4
5
6
7
8
9
10
11
App
Index
Automatic Parameter Setting Function
The AQ6370B provides a fit area/mask area automatic setting function.
AUTO-FIX
ASE algorithm
The fitting algorithm is LINEAR.
Since the algorithm is LINEAR, the mask area setting will not be required.
Obtain the left and right fit areas (NA_Ri, NA_Li) of each channel by using the number of
detected channels as follows.
When the number of channels “n” is 1
Internally obtain the measurement resolution of trace B and the value of the noise
measurement point NOISE AREA in accordance with the resolution, and obtain the fit
areas from the following equations.
NA_Ri =
λ
i + NOISE AREA
NA_Li =
λ
i - NOISE AREA
When the number of channels “n” is 2 or more
Obtain the channel spacing (spacing of
λ
i) of each channel. Set the minimum spacing to
SPACING and also use the following to obtain the NOISE AREA.
NA_Ri =
λ
i + NOISE AREA ( i =1,2,…,n )
NA_Li =
λ
i - NOISE AREA ( i =1,2,…,n )
AUTO-CTR
ASE algorithm
The fitting algorithm is LINEAR.
Since the algorithm is LINEAR, the mask area setting will not be required.
Obtain the left and right fit areas (NA_Ri, NA_Li) of each channel by using the number
of detected channels as follows (center points between channels are treated as NA_Ri,
NA_Li.)
When the number of channels “n” is 1
Internally obtain the measurement resolution of trace B and the value of the noise
measurement point NOISE AREA in accordance with the resolution, and obtain the fit
areas from the following equations.
NA_Ri =
λ
i + NOISE AREA
NA_Li =
λ
i - NOISE AREA
When the number of channels “n” is 2 or more
λ
N1 = (3
λ
1
-
λ
2
)/2
i=2,3,…,n
λ
Ni = (
λ
i
+
λ
i-1
)/2
λ
Nn+1 = (3
λ
-
λ
n-1
)/2
Perform the calculations.
i=1,2,…,n
NA_Li =
λ
Ni
NA_Ri =
λ
Ni+1
Appendix 5 Details of Optical Amplifier Analysis Function