YASKAWA CH700 - Page 40

40 YASKAWA ｜ YASKAWA AC Drive CH700
Catalog
｜ KAEP C710617 24
· Braking
Resistor Unit
· Braking Unit
*
Peripheral Devices and Options
Power Supply
1
Power
Regenerative
Unit R 1000
*
1
Earth Leakage
Circuit Breaker
(
ELCB
)
,
Molded Case
Circuit Breaker
(
MCCB
)
Magnetic
Contactor
AC Reactor
Zero Phase
Reactor
Fuse
Input Noise Filter
1
Power
Regenerative
Converter D1000
DC Reactor
Ground
USB Port
PC
Noise Filter
(
output side
)
Zero Phase
Reactor
Motor
Ground
Name
Purpose
Model, Manufacturer
Power Regenerative
Converter D1000
Effectively utilizes regenerative energy as energy for
other equipment.
Suppresses the power line harmonics
(
K 5
=
0
)
and
satisfies the Guidelines of Harmonics Reduction.
CIMR
-
DA □□□□
Power Regenerative
Unit R1000
Effectively utilizes regenerative energy as energy for
other equipment.
CIMR
-
RA □□□□
Earth Leakage Circuit
Breaker
(
ELCB
)
Always install an ELCB on the power
-
supply side to protect the
power supply system and to prevent an overload at the
occurrence of shortcircuit, and to protect the drive from ground
faults that could result in electric shock or fire.
Note
:
When an ELCB is installed for the upper power supply system, an
MCCB can be used instead of an ELCB. Choose an ELCB
designed to minimize harmonics specifically for AC drives. Use
one ELCB per drive, each with a current rating of at least 30 mA.
NV series *
2
by
Mitsubishi
Electric
Corporation
Molded Case Circuit
Breaker
(
MCCB
)
Always install a circuit breaker on the power
-
supply side
to protect the power supply system and to prevent an
overload at the occurrence of a short
-
circuit.
NF series*
2
by
Mitsubishi Electric
Corporation
Magnetic Contactor
Interrupts the power supply to the drive. In addition to
protecting drive circuitry, a magnetic contactor also
prevents damage to a braking resistor if used.
SC series *
2
by Fuji
Electric FA Components
& Systems Co., Ltd
AC Reactor
Improve the input power ratio of the drive. The DC
reactor is built in for models of catalog codes
CH7 0 A 2088 and above, and CH7 0 A 4045 and above.
(
The DC reactor is optional for models of catalog codes
CH7 0 A 2075 and below, and CH7 0 A 4039 and below.
)
・ Used for harmonic current suppression and total
improving power factor.
Should be used if the power supply capacity is larger
than 600 kVA.
・ Suppresses harmonic current
・ Improves the power factor of the input power supply
UZBA series
DC Reactor
UZDA series
Zero Phase Reactor
Reduces noise from the line that enters into the drive input
power system. Should be installed as close as possible to
the drive. Can be used on both the input and output sides.
F6045GB
F11080GB
F200160PB
by Hitachi Metals, Ltd.
Fuse / Fuse Holder
Protects internal circuitry in the event of component failure.
Fuse should be connected to the input terminal of the drive.
Note
:
Refer to the instruction manual for information on UL approval.
CR/CS series by
BUSSMANN
Input Noise Filter
Reduces noise from the line that enters into the drive
input power system.
Should be installed as close as possible to the drive.
Note
:
For CE Marking
(
EMC Directive
)
compliant models,
refer to CH7 00 Technical Manual.
RTEN seies by
TDK
-
Lambda
Corporation
B 84143 B series by
EPCOS, Inc.
FN series by
Schaffner EMC K.K.
Output Noise Filter
Reduces noise from the line that enters into the drive input power
system. Should be installed as close as possible to the drive.
LF series by NEC
Tokin Corporation
External Heatsink
Attachment for Braking Unit
Use the external heatsink attachment for installation with
the heatsink outside the enclosure.
EZZ021711A
Braking Resistor Unit
Used to shorten the deceleration time by dissipating
regenerative energy through a resistor unit
(
10 % ED
)
.
A thermal overload relay is built in
(
10 % ED
)
.
LKEB series
Braking Unit
Shortened deceleration time results when used with a
Braking Resistor Unit.
CDBR series
PC cable
Connect the drive and PC when using DriveWizard. The
cable length must be 3 m or less.
Commercially
available USB2.0
A
-
miniB cable.
LED Keypad
For easier operation using the LED screen when connecting
the optional LED Keypad to the drive.
Allows for remote operation.
Includes a Copy function for saving drive settings.
JVOP
-
KPLEA04AAA
KPLEA04MAA
Bluetooth LCD Keypad
Bluetooth connection enables the drive to be operated
from a smartphone.
JVOP
-
KPLCC 04 ABA
KPLCC04MBA
Keypad Extension
Cable
It is used as an extension cable when operating the
keypad remotely.
WV001
:
1 m
WV003
:
3 m
1
:
Select peripheral devices to match how regenerative energy is processed.
2
:
Recommended by Yaskawa. Contact the manufacturer in question for availability and specifications of
non
-
Yaskawa products.
DriveWizard
*
*
*