YASKAWA JEPMC-PSA3012-E - Motion Control Function Module Specifications

4.3 CPU Unit Specifications
Motion Control Function Module Specifications
4-10
Motion Control Function Module Specifications
The specifications of the Motion Control Function Module that is built into the CPU Unit are given in the
following table.
Item
Specification
Remarks
CPU-201 CPU-202
MECHA-
TROLINK
communica-
tions settings
Communications ASIC JL-100 −
Number of Communications
Lines
1 −
Number of Communications
Ports (Connectors)
2 −
Communications cycle (cycle
for refreshing data)
250 μs to
32.0 ms
125 μs to
32.0 ms
−
Master
Communications
Method
M-III −
Baud Rate 100 Mbps −
Communications
Cycle
125 μs/250 μs/0.5 ms/
1 ms/1.5 ms/2 ms/3 ms
−
Number of Con-
nected Stations
42 stations (up to 32 servo
stations)
−
Message Relaying Supported. −
C2 Messages Supported. Automatically set by the system.
Retries Supported. −
Asynchronous Set-
ting of High-speed
Scan Cycle and
Communications
Cycle
Not supported.
An alarm will occur if setting is
attempted.
Slave
Communications
Method
M-III −
Communications
Cycle
125 μs to 3.0 ms −
Slave CPU syn-
chronization
Supported. −