5 SETTING OPERATION CONDITIONS
61
5.4 INITIALIZE MODE
As described below, the access level to set/read constants or control method can be selected. Set
initialize mode constants before use of the VS-686SS5.
The following table shows the constants for initialize mode.
Table 25 Initialize Mode
Constant
No.
Name Description
A1-01
Access level
(change enable during run)
0 : Exclusive for monitoring
A1-01 can be set/readand U constants in QUICK-STARTlevelcanberead.
2 : QUICK-START
Constants required for quick-start operation can be set/read.
3 : BASIC
Constants required for basic operation can be set/read.
4 : ADVANCED
Constants required for advanced operation can be set/read.
A1-02 Control metod
5 : Open loop vector
6 : Flux vector
A1-03 Initialize
Constant initialization
2220 : 2-wire sequence
(Returns to the value set at the factory prior to shipment.)
3330 : 3-wire sequence
A1-04 Password 1 (for input) For future use (Do not set because of special function.)
To Next Page
Loading...
