YASKAWA YWE-EH500-6N0 - Page 116

15.3 Parameters for Welding Current Calibration Function
15-6
HW0480311
HW0480311
15.3 Parameters for Welding Current Calibration Function
The following tables show the parameters which are used for the welding current calibration
function.
Parameters used when the user file No.1 is selected
Parameters used when the user file No.2 is selected
Parameters used when the user file No.3 is selected
Display No. Item Initial Value Content
P62 Current output characteristic 1 100 Compensation ratio 1 for wire feed-
ing speed (Unit: %)
P63 Current output characteristic 2 100 Compensation ratio 2 for wire feed-
ing speed (Unit: %)
C13 Current calibration
Reference current 1 (File No.1)
150 Reference current 1 for the user file
No.1 (Unit: A)
C14 Current calibration
Reference current 2 (File No.1)
250 Reference current 2 for the user file
No.1 (Unit: A)
Display No. Item Initial Value Content
P62 Current output characteristic 1 100 Compensation ratio 1 for wire feed-
ing speed (Unit: %)
P63 Current output characteristic 2 100 Compensation ratio 2 for wire feed-
ing speed (Unit: %)
C15 Current calibration
Reference current 1 (File No.2)
150 Reference current 1 for the user file
No.2 (Unit: A)
C16 Current calibration
Reference current 2 (File No.2)
250 Reference current 2 for the user file
No.2 (Unit: A)
Display No. Item Initial Value Content
P62 Current output characteristic 1 100 Compensation ratio 1 for wire feed-
ing speed (Unit: %)
P63 Current output characteristic 2 100 Compensation ratio 2 for wire feed-
ing speed (Unit: %)
C17 Current calibration
Reference current 1 (File No.3)
150 Reference current 1 for the user file
No.3 (Unit: A)
C18 Current calibration
Reference current 2 (File No.3)
250 Reference current 2 for the user file
No.3 (Unit: A)
116/129