4.3 List of Process Parameters
4-16
HW0480311
HW0480311
4.3 List of Process Parameters
The welding characteristics (start/main conditions/end) that are specified by database in the
welding source can be adjusted according to your environmental conditions by changing the
set values of the process parameters (P parameters).
All the values are set to "100% = Operating as the characteristics in the database" before
shipping.
If the adjustment of welding characteristics is required, refer to " 13 Process Parameters
(Adjustment of Welding Characteristics) "
Display
No.
*1
Items Description
P00
C Wire slow-down speed
P01
C Wire speed at start
P02
C
Starting pulse peak current
P03
- Reserved for system Do not change.
P04
C Starting pulse peak time
P05
C Average value of hot current
P06
C Average value of hot voltage
P07
CHot time
P08
P Pulse current
P09
P Base current
P10
P Pulse time
P11
C Average current at ending VALID when the parameter D1-4=ON
P12
C Average voltage at ending VALID when the parameter D1-4=ON
P13
C End time VALID when the parameter D1-4=ON
P14
C Average current value at burning
P15
C Average voltage value at burning
P16
C Burning time
P17
C Droplet pulse peak current
P18
C Droplet pulse peak time
P19
- Reserved for system Do not change.
P20
C Wire-stick prevention time
To Next Page
Loading...