1-2
HW0480311
HW0480311
Voltage for Starting Point
Detecting Function
(Optional)
Peak value: 220 V
±20 % (full-wave rectification)
External Dimensions
[mm]
371 x 810 x 641 (width x depth x height)
(excluding the projections such as screws or eyebolts)
Mass Approx. 70kg
Welding Voltage Setting
Method
Can be switched by "Auto Adjustment/Individual" (Synergic/Indepen-
dent) button on the welding source panel.
Arc Touch Start Function This function can be used by the parameters D2-2, D2-3, and D2-4.
User File Number of files: 3
"Panel" or "robot" can be switched by the parameter D1-11.
Adjustment of Voltage
and Current Waveform
Control
Can be changed by P parameters in the user file.
Interface for Robot Con-
troller
Refer to " 10 Robot Interface Signals ".
Output Setting Analog
Input
0 to 14 V (The set voltage, current, and wire feeding speed are displayed
on the welding source panel.)
Error Output Outputs the arc failure signal to the robot side. (Error contents are indi-
cated on the welding source panel.)
Output for Arc
Monitoring
Outputs the signal corresponding to current or voltage to the robot side.
The output terminal stand for analog indicator is also available.
Power Supply of the
Heater for the Gas
Regulator
None
Standard Accessory Fuse contained in glass tube of 5A (2 fuse)
Fuse contained in glass tube of 10 A (1 fuse) for Pr(SD)-006 board
Remarks Front panel: Written in English
Item Specifications
To Next Page
Loading...