www.ydlidar.com Copyright 2015-2019 YDLIDAR
FIG 4 YDLIDAR G4 AUXILIARY POWER SUPPLY
To evaluate and develop the G4 under Windows, you need to install the serial port driver of the USB
adapter board. The USB adapter board of this kit adopts CP2102 chip to realize serial port (UART)
to USB signal conversion. Its driver can be downloaded from our official website or downloaded
from the official website of Silicon Labs.
http://ydlidar.com/
http://cn.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers
After decompressing the driver package, run the CP2102's Windows driver installation file (exe file
under CP210x_VCP_Windows). Please select the 32-bit version (x86) or 64-bit version (x64)
installation program according to the version of the windows operating system.
FIG 5 YDLIDAR G4 DRIVER VERSION SELECTION
To Next Page
