Yealink CP860 - Page 264

Administrator’s Guide for CP860 IP conference phones
252
TLV Type
TLV Name
Description
End of LLDPDU
Marks end of LLDPDU.
Optional TLVs
System Name
Name assigned to the IP phone.
The default value is “yealink”.
System Description
Description of the IP phone.
The default value is “yealink”.
System Capabilities
The supported and enabled phone
capabilities.
The supported capabilities are Bridge,
Telephone and Router.
The enabled capabilities are Bridge and
Telephone by default.
Port Description
Description of port that sends data unit.
The default value is “WAN PORT”.
IEEE Std 802.3
Organizationally
Specific TLV
MAC/PHY
Configuration/Status
Duplex and bit rate settings of the IP
phone.
The Auto Negotiation is supported and
enabled by default.
The advertised capabilities of PMD.
Auto-Negotiation is:
100BASE-TX (full duplex mode)
100BASE-TX (half duplex mode)
10BASE-T (full duplex mode)
10BASE-T (half duplex mode)
TIA
Organizationally
Specific TLVs
Media Capabilities
The MED device type of the IP phone and
the supported LLDP-MED TLV type can be
encapsulated in LLDPDU.
The supported LLDP-MED TLV types are:
LLDP-MED Capabilities, Network Policy,
Extended Power via MDI-PD, Inventory.
Network Policy
Port VLAN ID, application type, L2 priority
and DSCP value.
Extended
Power-via-MDI
Power type, source, priority and value.
Inventory –
Hardware Revision
Hardware revision of phone.