Yealink CP860 - Blacklist

Configuring Basic Features
45
Parameters
Permitted Values
Default
Description:
Enables or disables the IP phone to access its web user interface using HTTPS
protocol.
0-Disabled
1-Enabled
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network-> Advanced-> Web Server->HTTPS
Phone User Interface:
Menu->Settings->Advanced Settings (Default password: admin) ->Network->
Webserver Type-> HTTPS Status
network.port.https
Integer from 1 to 65535
443
Description:
Configures the HTTPS port for the IP phone to access its web user interface using the
HTTPS protocol.
The default HTTPS port is 443.
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Advanced->Web Server->HTTPS Port (1~65535)
Phone User Interface:
Menu->Settings->Advanced Settings (Default password:
admin)->Network->Webserver Type->HTTPS Port
To configure the web server type via web user interface:
1. Click on Network->Advanced.
2. In the Web Server block, select the desired value from the pull-down list of HTTP.
3. Enter the HTTP port in the HTTP Port (1~65535) field.
The default HTTP port is 80.
4. Select the desired value from the pull-down list of HTTPS.
5. Enter the HTTPS port in the HTTPS Port (1~65535) field.