Description:
Configures the interval (in seconds) for the IP phone to broadcast the LLDP request.
Note: If you change this parameter, the IP phone will reboot to make the change
take effect. It works only if the parameter “network.lldp.enable” is set to 1 (Enabled).
Web User Interface:
Network->Advanced->LLDP->Packet Interval (1~3600s)
Phone User Interface:
None
To configure LLDP via web user interface:
1. Click on Network->Advanced.
2. In the LLDP block, select the desired value from the pull-down list of Active.
3. Enter the desired time interval in the Packet Interval (1~3600s) field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after reboot.
5. Click OK to reboot the phone.
To Next Page
Loading...
