Register the CP935W to the W70B Base Station
1. After pressing the Reg option on the CP935W, it will search for a base station that is currently in registration mode.
2. After the phone is registered successfully, it will display the prompt Handset Subscribed and Base NO (the last 4
characters of the connected Base’s MAC address).
3. After the phone is initialized successfully, an icon with the internal number and name appears on the phone
screen.
Note: You can also press OK > Register Handset and then select the desired base to register the
handset. You need to enter the base PIN (default: 0000) after a base is found.
WiFi Setup
To configure the phone for Wifi operation:
1. Power up the CP935W unit.
2. At the Select mode screen, select WiFi Mode and press OK. The device will reboot.
3. When the phone is ready, press Cancel at the Searching for Wifi Assistant prompt.
4. Press ...More.
5. Press Basic.
6. Press Wifi.
7. Toggle the Wifi slider to enable it. The phone will scan for available WiFi networks.
8. Select your network security mode and enter your password information.
9. Press Connect.
10. Once the phone is connected, determine the IP address of the phone as follows:
11. Press ...More.
12. Press Status. Make a note of the IP address that is listed.
13. Finally, follow the steps in the following Support article to provision the phone as a regular Yealink phone:
◦ Manually Provision Phone into Production
https://support.8x8.com/devices-accessories/phones/yealink/Yealink_CP935W_Phone_DECT_and_WiFi_Configuration
Updated: Fri, 09 Feb 2024 21:08:10 GMT
Powered by
3
To Next Page
Loading...
