Yealink CP965 User Guide
4. Enter the desired password in the Password field.
5.
(Optional.) Tap to make the password visible.
6. Select Show advanced options to configure the HTTP proxy for the Browser.
7. Select Connect.
Once the connection has completed successfully, the prompt “Connected” appears under the corresponding
SSID.
Related Topic
Activating the Wi-Fi Mode
Adding a Wireless Network Manually
If your gateway/router has SSID broadcast disabled, it doesn't appear in the scanning results. Then you must manu-
ally add a wireless network.
Before You Begin
Get the available wireless network information from your system administrator. Make sure that the Wi-Fi mode is
activated.
Procedure
1. Go to More > Settings > Basic > Wi-Fi.
2.
Select > Add.
3. Enter the desired value in the Network SSID field.
4. Tap the desired value from the Security field.
l
If you select WEP or WPA/WPA2 PSK, enter the password.
l
If you select 802.1x EAP, tap the desired value from the EAP method field, and enter additional information.
5.
(Optional.) Tap to make the password visible.
6. Select Show advanced options to configure the HTTP proxy for the Browser.
7. Select Save.
Related Topic
Activating the Wi-Fi Mode
Viewing the Wireless Network Information
You can view the detailed wireless network information, such as Profile Name, SSID and Signal Strength.
Procedure
1. Go to More > Settings > Basic > Wi-Fi > Wi-Fi Status.
2.
(Optional.) Drag up and down to scroll through the list of wireless network information.
Disconnect from a Wireless Network
You can disconnect the wireless network connection from your phone.
Procedure
1. Go to More > Settings > Basic > Wi-Fi.
2.
Tap the connected SSID (the top one).
3. Select Forget.
Tip: You can also disconnect from the wireless network by deactivating the Wi-Fi mode.
104
To Next Page
Loading...
Need help?
General
Weight and Dimensions
