EasyManuals Logo

Yealink CTP18 Administrator's Guide

Yealink CTP18
281 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #175 background imageLoading...
Page #175 background image
| Configuring Video Settings | 175
Parameter Description Configuration Method
HDMI 2
(it is not applicable to
MeetingEye 400/PVT940/
VC200/VC200-E/VP59)
Set the output resolution of the
HDMI 2 display device.
• Auto-select the highest
output resolution
automatically.
• The available output
resolutions (The available
resolutions depend on the
monitor you are using).
Default: Auto. It is configurable
only when HDMI 2 display is
enabled.
Web user interface
CP960 Conference Phone
Configuring VC200 Experimental Access (Auto Framing)
The experimental access feature currently includes the auto framing, which is mainly based on face
detection. Real-time detection and position tracking are performed on all faces in the conference room. The
camera can be automatically adjusted according to the number of participants and position changes. All
participants are covered in the output screen.
About this task
Attention: Note the following points when using the VC200 experimental access feature:
• After the auto framing is enabled, other devices cannot perform PTZ control on the VCS camera,
and the camera preset function does not take effect.
• The number of face detections on the VC200 can support up to 8 faces simultaneously in a
range of 5 meters.
• The experimental access is a new feature that Yealink is exploring. It is available to users for trial
use in advance, and may have unstable problems. It is not recommended as a daily function.
Procedure
1. On your web user interface, go to Security > Experimental Access.
2. Configure and save the following settings:
Parameter Description Configuration Method
Experimental Access
It is configurable only after the
experimental access is enabled.
Note: the default value is Off. It takes 5
consecutive confirmations to activate the
experimental access feature.
Web user interface

Table of Contents

Other manuals for Yealink CTP18

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink CTP18 and is the answer not in the manual?

Yealink CTP18 Specifications

General IconGeneral
Aspect ratio16:10
Display diagonal8 \
Display resolution1280 x 800 pixels
Touchscreen technologyCapacitive
Built-in speaker(s)No
Ethernet LANYes
Mounting typeWall/Tabletop
Product colorBlack, Grey
RJ-45 ports quantity1
Cables includedLAN (RJ-45)
Power source typeDC
Power consumption (typical)7 W
Weight and Dimensions IconWeight and Dimensions
Depth100 mm
Width202 mm
Height151 mm

Related product manuals