Yealink CTP18 Administrator's Guide

| Configuring Network Settings | 72
Procedure
1. Do one of the following:
• On your web user interface, go to Network > LAN Configuration > IPv6 Config.
• On your VCS: go to More > Settings > Network Setting > Wired Network > IPv6.
For VP59, tap > Settings > Network Setting > Wired Network > IPv6.
•
On your CTP20/CTP18, tap > Settings > Network Setting > Host Network > Network > Wired
Network > IPv6.
2. Configure and save the following settings:
Parameter Description Configuration Method
DHCP
Enable or disable the system to
obtain network settings from the
DHCP server.
Note: the default value is On.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20/CTP18
Static IP
Enable or disable the system
to manually configured IPv6
network settings.
Default: Off.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
IP Address
Configure the IPv6 address
assigned to the system.
Note: It is configurable only
when the network type is
selected as Static IP.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20/CTP18
IPv6 prefix((0~128)/
IP prefix
Configure the IPv6 prefix.
Note: It is configurable only
when the network type is
selected as Static IP.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20/CTP18

Yealink CTP18 Specifications

General

Aspect ratio	16:10
Display diagonal	8 \
Display resolution	1280 x 800 pixels
Touchscreen technology	Capacitive
Built-in speaker(s)	No
Ethernet LAN	Yes
Mounting type	Wall/Tabletop
Product color	Black, Grey
RJ-45 ports quantity	1
Cables included	LAN (RJ-45)
Power source type	DC
Power consumption (typical)	7 W

Weight and Dimensions

Depth	100 mm
Width	202 mm
Height	151 mm