Yealink One Talk W78B - Handset Registration; Base Station Registration Mode; Registering a New Handset

User guide
12
Entering data on the W78HV
The following table describes how to enter different characters using the keypad keys:
Task
Action
Switch among input modes.
Press to switch among input modes.
The current input mode is displayed at the right bottom of the phone screen.
Enter letters.
Press a key one or more times (depending on what input mode you’re in) to enter the possible characters
that are displayed on the keypad key.
Enter special characters.
Press to enter the space character or the following special characters: _’ ”
= / \ ^ ; : , . - + * # § % & @ ? ! ¿ ¡ ( ) { } [ ] < > ¥
￡
$ | ~ ¤ Press :
• If it is in the uppercase (ABC), uppercase and lowercase (Abc) or lowercase (abc) input modes, it will
provide space character and the following special characters: . , ? ! 0
• If it is in the numeric (123) input mode, it will only provide the digit 0
• Long press the key to enter the character +
Delete the text.
Press / or / to position the cursor to the right of the text you want to delete, and then press Delete
to delete one character at a time or long press to delete all characters.
Handset registration
You need to register your handset to a base station, if you want to use the basic functions of the DECT phone. You can register a handset to 4
different base stations at most. You can select the desired base to use.
Note: Up to 5 handsets can be registered to one base station.
Putting the base station into registration mode
Before registering the handset, you have to put the base station into registration mode.
Procedure
1. Long press on the base station till the registration LED flashes
The base station is now in registration mode
Note: If the base station does not identify a DECT phone within 90 seconds, the registration mode will switch off automatically.
Registering a new handset to a base station
With one touch, you can quickly register your new handset to a base station.
Before you begin
Make sure the base station is in the registration mode, and the phone prompts "Unregistered!".
Procedure
1. Press the Reg soft key to register the handset
The handset is searching for a base station in registration mode
After the handset is registered successfully, the phone prompts “Handset Subscribed” and “Base NO. (The last 4 characters of the connected Base’s
MAC address)”.