User guide
42
Procedure
1. Go to OK > Settings > Bluetooth > My Devices
The phone screen displays the device name
2. Enter the desired name in the Device Name field
3. Confirm the action
Maintaining your phone
When your phone cannot operate properly, you need to investigate or troubleshoot issues along with other tasks that your administrator may ask
you to perform.
Investigating warnings
When the default password is used on the phone, you can view the warning details about the issue from Status screen.
Procedure
1. Go to OK > Status > Base
The warning detail is displayed in the Warning (Warnings) field
Restarting the base station
The improper operation may cause malfunction. If a malfunction occurs, your system administrator may ask you to restart the base station to
refresh the settings.
Procedure
1. Go to OK > Settings > System Settings > Base Restart
2. Enter the system PIN (default: 0000), and then press Done
3. Confirm the action
Results
After the above steps, the registration LED and network status LED on the base station go out simultaneously. After a period of time, the LED
indicators will glow green again when the base station restarts successfully.
Resetting the base station
Your system administrator may ask you to reset your phone to factory after you have tried all troubleshooting suggestions but still do not solve the
problem.
Except the handset registrations, the phone will reset all settings to the factory defaults after the resetting. Check with your system administrator if
the personalized settings are kept before resetting your phone to factory.
Procedure
1. Go to OK > Settings > System Settings > Base Reset
2. Enter the system PIN (default: 0000), and then press Done
3. Select Reset to factory
A message prompts whether to reset the base
4. Confirm the action
To Next Page
Loading...
