Yealink SIP-T19P E2 User Manual

Recovery Mode on Yealink IP phones
11
5. Press to verify the current firmware version after upgrading successfully.
Note
For VCS (Video Conferencing System) Series
The section is only applicable to the VCS series including VC400, VC120, and VC110.
The following procedures take the VC400/VC120 for reference.
Procedures
1. Long press the recessed Reset key (Use the tip of a pin to hold the reset key) and press on the
codec to trigger the recovery mode. Do not release the Reset key until the recovery mode wizard
appears on the display device.
Note
2. Enter the desired values in the IP Address, Netmask, IP Gateway and TFTP Server fields
respectively.
The IP phone must be configured in the same subnet as the TFTP server.
3. Press on the remote control to complete the recovery mode.
The video conferencing system will download and upgrade the firmware from the TFTP server. After
upgrading, the video conferencing system will initialize successfully and get ready for use.
4. Press on the VCP40 phone to verify the current firmware version after upgrading successfully.
You need to press (for SIP-T19(P) E2 IP phones), tap ->Status (for SIP VP-T49G IP
phones), tap Settings->Status (for VP59/SIP-T58A IP phones) or tap Menu->Status (for
SIP-T57W IP phones), (for SIP-T3 IP phones) to verify the current firmware version since
there is no key.
For VC110, you need to long press the Reset key and reconnect the power adapter to trigger the
recovery mode.
IP Address:
Netmask:
IP Gateway:
TFTP Server:
10. 2. 11.124
255.255.255. 0
10. 2. 11.254
10. 2. 11.123
…. Update Fail ….
Please reboot
Welcome

Yealink SIP-T19P E2 Specifications

General

Handset type	Wired handset
Product type	IP Phone
Product color	Black
Volume control	Digital
Integrated voicemail	Yes
Keypad number of keys	29
Number of function keys	6
Number of programmable keys	7
Cables included	AC, DC, LAN (RJ-45)
Number of handles included	1 pc(s)
Voice codecs	G.711, G.722, G.726, G.729B
Input current	0.25 A
Input frequency	50/60 Hz
AC adapter input voltage	100 - 240 V
AC adapter output current	0.6 A
AC adapter output voltage	5 V
Power consumption (typical)	1.25 W
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	-
Dual-Tone Multi-Frequency (DTMF) modes	In-band, Out-of band, SIP info
Display diagonal	2.3 \
Display resolution	132 x 64 pixels
Security algorithms	HTTPS, MD5, SRTP
Networking standards	IEEE 802.1p, IEEE 802.1x
Ethernet LAN (RJ-45) ports	2
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Harmonized System (HS) code	85171800

Weight and Dimensions

Depth	143 mm
Width	185 mm
Height	38 mm
Package depth	200 mm
Package width	215 mm
Package height	121 mm
Package weight	996 g