Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
281
Description
It configures the location on the phone screen for soft key X.
Note: It works only if “features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1
(Enabled).
Permitted
Values
Integer from 0 to 10
If it is set to 0, the soft key X is located in the first available position from the left.
If it is set to other values, a More soft key appears and the soft key X is located in the specified pos-
ition. The following soft keys are moved by one position to the right. Press the More soft key to view
the remaining soft keys.
Default
0
Parameter
softkey.X.action
[1]
<y0000000000xx>.cfg
Description
It configures the action or function for custom soft key X.
This value uses the same macro action string syntax as an Enhanced DSS key.
You can also invoke the EDK macro that was already defined. The macro name follows the character
“!”.
Example:
softkey.1.action = !macro1
In this example, macro1 stands for the macro name configured by the parameter “edk.edk-
list.X.mname”.
Note: It works only if “features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1
(Enabled).
Permitted
Values
String
Default
Blank
Parameter
softkey.X.softkey_id
[1]
<y0000000000xx>.cfg
Description
It configures the softkey id for custom soft key X.
Example:
softkey.1.softkey_id = custom_macro1
Note: It works only if “features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1
(Enabled).
Permitted
Values
String
Default
Blank
Parameter
softkey.X.use.idle
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the idle state.
Note: It works only if “features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1
(Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
softkey.X.use.incoming_call
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the alerting (ringing) state.
To Next Page
Loading...
Need help?
General
