Yealink SIP-T2

Advanced Features
452
Example:
blf.enhanced.callout.led = $LEDg1000o$
For T57W/T48U/T48S/T48G phones, the BLF/BLF List DSS key field displays a green icon for 1000ms
and then turns to white.
For other phones, the BLF/BLF list DSS key LED glows green for 1000ms and then goes out.
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled).
Permitted
Values
String
Default
Blank
Supported
Devices
All phones except T30P, T30, T19(P) E2 and CP920
Parameter
blf.enhanced.callout.callin.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is ringing and mon-
itored user is calling out.
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled).
Permitted
Values
String
Default
Blank
Supported
Devices
All phones except T30P, T30, T19(P) E2 and CP920
Parameter
blf.enhanced.callout.talking.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is talking and mon-
itored user is calling out.
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled).
Permitted
Values
String
Default
Blank
Supported
Devices
All phones except T30P, T30, T19(P) E2 and CP920
Parameter
blf.enhanced.callout.idle.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is idle and monitored
user is calling out.
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled).
Permitted
Values
String
Default
Blank
Supported
Devices
All phones except T30P, T30, T19(P) E2 and CP920
BLF Key LED/Icon and Behavior for Talking State Configuration
The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for talking state
(the monitored user is talking).
Parameter
blf.enhanced.talking.enable <y0000000000xx>.cfg