Yealink SIP-T2

Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
425
You can configure a directed call pickup code and pick up the incoming call using the DPickup soft key.
Tip: You can set a DSS key as a Directed Pickup key, and specify a contact you want to pick up a call from for this key. For
more information, refer to DSS Keys.
The following table lists the parameters you can use to configure directed call pickup.
Parameter
features.pickup.direct_pickup_enable <y0000000000xx>.cfg
Description
It enables or disables the user to use DPickup soft key when performing the directed call pickup fea-
ture.
Permitted
Values
0-Disabled
1-Enabled, the phone will display the DPickup soft key on the Dialing screen.
Default
0
Web UI
Features > Pick up & Park > Directed Call Pickup
Parameter
features.pickup.direct_pickup_code <y0000000000xx>.cfg
Description
It configures the directed call pickup code on a phone basis.
Note: The code configured by "account.X.direct_pickup_code” takes precedence over that configured
by this parameter.
Permitted
Values
String within 32 characters
Default
Blank
Web UI
Features > Pick up & Park > Directed Call Pickup Code
Parameter
account.X.direct_pickup_code
[1]
<MAC>.cfg
Description
It configures the directed call pickup code.
Note: The code configured by this parameter takes precedence over that configured by “fea-
tures.pickup.direct_pickup_code”.
Permitted
Values
String within 32 characters
Default
Blank
Web UI
Account > Advanced > Directed Call Pickup Code
[1]
X is the account ID. For T57W/T54W/T48U/T48S/T48G/T46U/T46S/T46G/T29G, X=1-16; for
T53W/T53/T43U/T42G/T42U/T42S, X=1-12; for T41P/T41S/T27G, X=1-6; for T33P/T33G, X=1-4; for
T40P/T40G/T23P/T23G, X=1-3; for T31P/T31G/T31/T21(P) E2, X=1-2; for T30P/T30/T19(P) E2/CP920, X=1.