EasyManuals Logo

Yealink SIP-T53 Getting Started

Yealink SIP-T53
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
Recovery Mode on Yealink IP phones
14
2. Click OK twice to save the settings.
3. Long press and reconnect the power adapter to trigger the recovery mode.
The W90DM/W90B will download and upgrade the firmware from the TFTP server.
You can view the syslog of the TFTP server to check if the W90DM/W90B downloads the firmware
successfully as shown below:
4. Find the current IP address of the device on the DHCP server in the list of registered DHCP clients.
Using Recovery Mode on Yealink IP Phones
(USB Flash Drive)
This section introduces how to perform recovery mode using USB flash drive on Yealink IP phones step
by step.
For MP54/MP56/MP58/VP59/SIP-T58A/T57W/T54W/
T53W/T53/T48U/T48S/T46U/T46S/T43U/T42U/T42S/T41
S/CP920 IP Phones
This section is only applicable to SIP phone series including MP54, MP56, MP58, CP920, SIP-T41S,
SIP-T42S, SIP-T42U, SIP-T43U, SIP-T46S, SIP-T46U, SIP-T48S, SIP-T48U, SIP-T53, SIP-T53W,
SIP-T54W, SIP-T57W, SIP-T58A, and VP59.
The following procedures take the SIP-T46S IP phone for reference.

Other manuals for Yealink SIP-T53

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T53 and is the answer not in the manual?

Yealink SIP-T53 Specifications

General IconGeneral
NetworkDual-port Gigabit Ethernet
SIP Accounts12
Lines12
Stand IncludedYes
PoEYes (IEEE 802.3af)
USB Port1 x USB 2.0
Headset SupportRJ9 and USB
Audio FeaturesHD Voice
Expansion Module SupportYes, up to 3
Voice CodecsG.722, G.711
Network FeaturesIPv4/IPv6, VLAN, QoS
Local Phonebook1000 entries
MountingDesk mount, Wall mount
Power SupplyOptional
Weight1.1 kg
Resolution360 x 160

Related product manuals