Yealink T19P

Appendix
75
Parameter
Permitted
Values
Descriptions
Web Setting Path
SIP-T19P IP
phones)
The default value is 0.
It takes effect after a reboot.
openvpn.url =
(not
applicable to
SIP-T19P IP
phones)
URL within
511
characters
It configures the access URL of the *.tar
file for OpenVPN.
The default value is blank.
Network->
Advanced->VPN-
>Upload VPN
Config
network.lldp.e
nable =
0 or 1
It enables or disables LLDP feature.
0-Disabled
1-Enabled
The default value is 1.
It takes effect after a reboot.
Network->
Advanced->LLDP-
>Active
network.lldp.p
acket_interval
=
Integer from
1 to 3600
It configures the interval (in seconds)
for the phone to broadcast the LLDP
request.
The default value is 60.
It takes effect after a reboot.
Network->
Advanced->LLDP-
>Packet Interval
(1~3600s)
network.span_
to_pc_port =
0 or 1
It enables or disables the phone to
span data packets received in the
WAN port to the PC port. If it is
enabled, all packets from WAN port
can be received by PC port.
0-Disabled
1-Enabled
The default value is 0.
It takes effect after a reboot.
Network->
Advanced->Span
to PC->Span to PC
Port
sip.reg_surge_
prevention =
Integer from
0 to 60
It configures the maximum duration (in
seconds) for account register after
startup.
The default value is 0.
It takes effect after a reboot.
Network->
Advanced->
Registration
Random->
Registration
Random (0~60s)
sip.send_resp
onse_by_requ
est =
0 or 1
It configures from where the phone
retrieves the destination address for
response. The phone will then send all
SIP response messages to the
destination address.