Press or Hold during an active call.
To Resume the call, do one of the following:
•If there is only one call on hold, press or Resume.
•For more than one call on hold, press or to select the desired call, and then press or Resume.
Transferring a Call
You can transfer a call in the following ways:
Performing a Blind Transfer
1.Press or Transfer during an active call. The call is placed on hold.
2. Enter the number you want to transfer to.
3.Press or B Transfer.
Performing a Semi-Attended Transfer
1.Press or Transfer during an active call. The call is placed on hold.
2. Enter the number you want to transfer to, and then press Send .
3.Press or Transfer when you hear the ring-back tone.
Performing a Attended Transfer
1.Press or Transfer during an active call. The call is placed on hold.
2. Enter the number you want to transfer to, and then press Send .
3.Press or Transfer when the second party answers.
Initiating a Conference Call
1. Press Conference during an active call. The call is placed on hold.
2. Enter the number of the second party, and then press Send.
3. Press Conference again when the second party answers. Three parties are now joined in the conference.
Note: You can split the conference call into two individual calls by pressing Split
To use the speed dial key:
Press the speed dial key to dial out the preset number.
Holding and Resuming a Call
To Hold a call:
Listening to Voice Mails
Message waiting indicator on the idle screen indicates that one or more voicemail messages are waiting at the
message center. The power indicator LED slowly flashes red.
To listen to voice mails:
1.Press or Connect.
2. Follow the voice prompts to listen to your voicemail messages.
To Next Page
Loading...
Need help?
General
