Yealink VC800 - Page 4

Steps：
1
3
2
4
3
Open the baffle.
Push the bracket along the track of the V800 codec.
Remove one Velcro.
Put the bracket on the top of the TV.
Stick a Velcro onto the back of the TV, and make sure that the bracket and the back of the TV are tightly positioned against each
other.
TV
5
4
5
Pay attention to the direction of the bracket
Mount on top of a TV
Put on a Flat Surface
You can put the system on a conference room table, and make sure that the slope is not more than 15 degrees so that the system
can operate correctly.
Please choose the following installation method when the thickness of the TV is between 50mm and 100 mm.
TV
5
6
4
3
2
1
2
3
1
Pay attention to the direction of the bracket
If your system cannot be mounted on the top of a TV when the bracket has
reached the given location, remove the bracket, and then convert its direction.
Refer to the following section for more information.
2
The system may fall down when the thickness of the TV is more than 100 mm. In this situation, do not mount the system on the
top of a TV.
Please choose the following installation method when the thickness of the TV is between 16mm and 55mm.