| Connecting a Mobile Phone to your CP930W/CP935W via Bluetooth | 90
4. Select the desired value from the Confirmation field.
5. Select the desired value from the Low Battery field.
6. Confirm the action.
Setting the Vibrator
By default, the phone simultaneously vibrates and rings when receiving an incoming call.
About this task
It is only applicable to W59R/W78H.
The following vibration settings are available for the incoming call:
• Vibrate and Ring: The handset will simultaneously ring and vibrate.
• Vibrate: The handset will vibrate only.
• Vibrate then Ring: The handset will vibrate four times and then start ringing.
• Off
Note: If the silent mode is activated, the handset will not vibrate and ring.
Procedure
1. Go to OK > Settings > Audio > Vibrator.
2. Select the desired method.
Disabling the Noise Cancellation
Noise cancellation helps improve intelligibility of speech in noisy environments. You are allowed to disable
it.
About this task
It is only applicable to W59R/W73H/W78H.
Procedure
1. Go to OK > Settings > Audio > Noise Cancellation.
2. Disable the noise cancellation.
3. Confirm the action.
Connecting a Mobile Phone to your CP930W/CP935W via
Bluetooth
Bluetooth enables low-bandwidth wireless connections within a range of 10 meters (32 feet). The best
performance is in the range of 1 to 2 meters (3 to 6 feet).
You can pair and connect the Bluetooth-enabled mobile phone with your phone. After connection, you can
do the following:
• Make and receive mobile calls on the phone
• Use the phone as a Bluetooth speaker for your mobile phone to play music.
To Next Page
Loading...
Need help?
General
