NeoGate TG Series User Manual
7/62
2. System Setup
2.1 SIM Card Placement
Insert the SIM card on the front panel directly before powering on NeoGate. To
remove this card, press the button on the left side, the card will pop directly. If
you are using NeoGate TG100, you should open the box before installing SIM
card on the board directly.
Notes:
1. The SIM card should be mini-SIM (2FF).
2. Please cut off the power before installing SIM card. You can also log in Web
interface to power this module off separately.
2.2 Antenna Connection
NeoGate is equipped with antenna connector for all the GSM/UTMTS/CDMA
modules. The external antenna should be installed vertically always on a site
with a good wireless signal.
To Next Page
Loading...
Need help?
General
