Configuration Code Turn on
第 39 页 共 22 页
configuration instruction and example
Barcode length limit configuration example
When configuring the minimum barcode length limit, you must ensure that the minimum length of the
configuration is not greater than the current maximum length configuration. Otherwise, an error will be
displayed. For the same reason, when configuring the barcode maximum length limit, you must also
ensure that the maximum length of the configuration is not less than the current minimum length
configuration.
Example 1: Configuring Code 128 barcode length is 4-12 digits
Scan the configuration code Code 128 minimum length limit, then scan the appendix data and edit the 4
in the barcode, save,
Scan the configuration code Code 128 maximum length limit, then scan the appendix data and edit the 1,
2, and save the barcode to complete the configuration.
Example 2: Configure Interleaved 2 of 5 barcode length to 14 digits
Configure Interleaved 2 of 5 barcode length 14 bits directly by scanning the quick configuration barcode
“ITF25 14-bit length”, or configure the maximum length and minimum barcode length:
Scan the configuration code Interleaved 2 of 5 minimum length limit, then scan the appendix data and edit
the bar code 1, 4, save,
Scan the configuration code Interleaved 2 of 5 maximum length limit, then scan the appendix data and
edit the 1, 4, and save the barcode to complete the configuration.
Example 3: Configure the Code 39 barcode length to any length supported.
Scan the configuration code Code 39 minimum length limit, then scan the appendix data and edit the 0 in
the barcode, save,
Scan the configuration code Code 39 maximum length limit, then scan the appendix data and edit the 0 in
the bar code, save, that is, complete the configuration.
USB keyboard send speed configuration example
If the performance of the client PC is weak and the transmission error is easy to occur, you need to
customize the USB keyboard transmission speed to a slower speed, such as 50ms:
Scan the configuration code Customize the sending speed, then scan the appendix data and edit the 5,0
in the barcode to save the configuration.
To Next Page
Loading...
