YOKOGAWA AXG005 - Operation Precautions; Maintenance and Repair Policy; Specific Conditions of Use

IM 01E21A03-01EN
12
<2. Explosion Protection Type>
12
2.4 Operation
• Take care not to generate mechanical spark when
access to the product and peripheral devices in
hazardous locations.
• Take care the following warning marking when
the opening the cover.
Integral Flowmeter and Remote Transmitter
• Take care the following warning marking “AFTER
DE-ENERGIZING, DELAY 20 MINUTES
BEFORE OPENING”.
Remote Sensor
• Take care the following warning marking “OPEN
CIRCUIT BEFORE REMOVING COVER”.
2.5 Maintenance and Repair
Only personnel authorized by Yokogawa Electric
Corporation can repair the equipment
2.6 Specic Condition of Use
• In the case the electrodes and/or grounding rings
are made of titanium, the sensor should be kept
away from impacts and frictions in hazardous
locations.
• Electrostatic charges on the non-metallic
parts(excluding glass parts) or coated parts of the
product shall be avoided.
• The applicable temperature class, ambient
temperature range and process temperature
range of the product are shown in Table 2.1 and
Table 2.2.
• From the sufety point of view the intrinsically
safe circuit of product shall be assumed to be
connected to ground.
• The product shall be installed as over-voltage
category II.
• Remote sensor, for connection to a Remote
Transmitter authorized by Yokogawa Electric
Corporation.